question about wheel spacers

[Midias]

if i remove the washer on the stock lug nuts it gives me 2mm more to work with so that is a total of 14mm thread length so if i put 8mm spacers that leaves me 6mm of thread left do you guys think that will be enough.what size are the ichaba spacers midas and how many of the 5mm spacers do you have guy

I have 2 ichiba 5mm spacers with a stock hub size

[ThatVietGuy]

As long as you can get at least 3 full turns in, you should be fine.

The lug nuts don't even fit in my Infiniti wheels, but they hold up just fine.

[Midias]

Do you want them D money because someone else just sent me a PM and does.

[D-money]

i have ordered some 8mm spacers but thanks for your offer

[D-money]

for anyone that wants to know the 8mm fit great with no problems here is a link to the ones i bought http://cgi.ebay.com/ebaymotors/PAIR-OF- ... ccessories

[t3chnique]

did you get extended studs with those?

[ASG14]

if i remove the washer on the stock lug nuts it gives me 2mm more to work with so that is a total of 14mm thread length so if i put 8mm spacers that leaves me 6mm of thread left do you guys think that will be enough.what size are the ichaba spacers midas and how many of the 5mm spacers do you have guy

Your either a dumbass or you got smart and didn't do that, which I'm hoping.

Have fun when your wheel snap off.

I have 3mm spacers in the rear and would not go over that without getting longer studs.

[D-money]

I did not get the extended studs and i did get smart and not take off the washers there was no need it seems to me that the stock alloys on the gen 1s are hub centric and lug centric is that possable?