OBX is showing us some V6 header love

[Midias]

Should not be bad coming out of that section. If it was going in I might grind more of an edge on each weld but I think this will flow just fine.

What diameter is the Y pipe at he rear flange 2.5 or 3 inch.

[Eye8Pussies]

^ that's what I was about to say too, considering the flow of the exhaust, it's not an issue at all...plus, a lot of 3-way collectors are exactly like that


and not sure...but most likely 2.5" since the collector's 2.5"

[Midias]

^^ yea now I am considering getting one but I am waiting for dawgs to dyno one.

[Dawgz]

Welds don't look too bad.


^^
But the merger doesn't looks that of a smooth transition.

Well, they are pipes bro, how else would u want them to be?

[Dawgz]

^^ yea now I am considering getting one but I am waiting for dawgs to dyno one.

a bunch of the East Coast guys are doing a GB on this.


Myself, King, Adam, Cisco, Sydmoid, Ptballer is a maybe....i may have left someone out....but yea...so we should all be dynoing around the same time...well king adam, cisco and I atleast.

[Solarizona]

Has anyone installed these yet?

[Eye8Pussies]

not yet...should be soon though. before the year is over we'll know

[TRDSleeper]

I'll most likely get these headers in the next couple of months because they are much more affordable than the JPP set up. Then I'll get a local shop to cut off the resonator and install a high flow cat instead.

[Midias]

^ Take some pictures of install for the rest of us.

[M_ABILLONES]

How much for the GB??? 03 Solara SLE V6

Gabe