Running dangerously rich.. need help diagnosing
I went to the dyno shop again today. I'm running even richer now with my OBX Headers and Jim's Fuel Mod than I was before!!! I'm also throwing a CEL P1410 since the header install.
P1410 = Valve position sensor fault (malfunction)
You'll see with the dyno from today posted below that there is a huge variance between runs, and my AFR drops as low as 9.8:1 AFR!!! Something is making my computer freak out and dump fuel into my engine. You'll also notice that the Closed Loop is running fine at 14.6:1 AFR
CURRENT Dyno 2 Date: 3/11/10 (w/ OBX headers and Jim's fuel mod)
PAST Dyno 1 Date: 3/5/10 (stock manifold and exhaust w/ Injen intake)
Here are some possible causes that people have mentioned (though no one seems confident about any of these being the problem)
1. Dirty MAF
2. Injen intake causing problems (doubt it!)
3. O2 Sensors dirty/faulty
4. Injectors stuck open
4. Broken EGR (EGR is snapped which might be causing the CEL but probably not the richness, from what I understand. Probably not the cause because I was already running rich before it snapped i think)
5. Disconnected vacuum line.
6. Leaking manifold/exhaust (This was a problem before, but entire exhaust and gaskets has been replaced with OBX and JP, should be fixed)
Today I'm going to do three things. I'm going to clean my MAF sensor, check for disconnected vac lines, and SeaFoam to look for exhaust leaks.
If anyone has any experience, suggestions, or ideas on which of those listed you think it may be or something not listed, please let me know. Any input is greatly appreciated. I know if anyone has the answer... it's the awesome SolaraGuy community.
P1410 = Valve position sensor fault (malfunction)
You'll see with the dyno from today posted below that there is a huge variance between runs, and my AFR drops as low as 9.8:1 AFR!!! Something is making my computer freak out and dump fuel into my engine. You'll also notice that the Closed Loop is running fine at 14.6:1 AFR
CURRENT Dyno 2 Date: 3/11/10 (w/ OBX headers and Jim's fuel mod)

PAST Dyno 1 Date: 3/5/10 (stock manifold and exhaust w/ Injen intake)

Here are some possible causes that people have mentioned (though no one seems confident about any of these being the problem)
1. Dirty MAF
2. Injen intake causing problems (doubt it!)
3. O2 Sensors dirty/faulty
4. Injectors stuck open
4. Broken EGR (EGR is snapped which might be causing the CEL but probably not the richness, from what I understand. Probably not the cause because I was already running rich before it snapped i think)
5. Disconnected vacuum line.
6. Leaking manifold/exhaust (This was a problem before, but entire exhaust and gaskets has been replaced with OBX and JP, should be fixed)
Today I'm going to do three things. I'm going to clean my MAF sensor, check for disconnected vac lines, and SeaFoam to look for exhaust leaks.
If anyone has any experience, suggestions, or ideas on which of those listed you think it may be or something not listed, please let me know. Any input is greatly appreciated. I know if anyone has the answer... it's the awesome SolaraGuy community.
- SirThomas8
- Regular SolaraGuy Member
- Posts: 169
- Joined: Mon Dec 07, 2009 11:58 pm
- Location: Baltimore & Washington D.C.