updated pics

[DaZanY4002]

It looks nice, but I think I'll agree with lilm on the fogs. For me the corner lights and the fogs seem to clash just a little bit. A black housing setup sometime in the future would look ill. Everything else looks very good!

[x99suplarax]

Lol I did use the brick edging.. And I cut the ends off as well lol also I don't snow board or skateboard.. Don't see a reason to have one.. But It would prolly look good.. And nice to have one for fun! Lol

[x99suplarax]

Toysol, you didn't need to cut off edges? Did you pull hard to make it flush?

[Toy1mzfe]

From pictures, it looks liek both u and Toysol had the lip on the bumper..

My lip just sits on the Edges and thats how they were mounted.

[ToyoSolV6]

I did have it on the bumber at first then that one tore off, then i used brick edging with double sided tape to make the lip flush and i had no issues with how it fit, i didnt have to cut the sides beacuse it fit right in. After everything was done i used four screws to hold in place and then so you wouldnt see any gaps between the lip i bought black silicone tube and put it in there.

[ToyoSolV6]

heres a pic of my car where u can see the lip this past saturday at the sg meet

[Sol-Toy]

paint the car red and keep the rims! DOPE!

[x99suplarax]

lol i have noticed a long time ago that you have the same rims as me haha after i bought it i saw a video of yours and i was like.. oh i guess i wasnt the first haha

[t3chnique]

This pic above looks a lot like the one below. haha

[x99suplarax]

haha yes looks very similar!