LED headlight housings for Gen 1

by **Ilovemylara** » Thu Sep 24, 2009 5:14 am

http://www.youtube.com/watch?v=NUehPthh ... re=related

by **DrLove** » Thu Sep 24, 2009 7:35 am

must be an expensive mods! but it looks very clean, this company makes awsome work if I look others youtube videos

Website · by **99BlackSandv6** » Thu Sep 24, 2009 8:23 am

That would be easy to do yourself. They are making huge profits I bet.

by **mazen222** » Thu Sep 24, 2009 8:33 am

thats looks sweet man!

by **Pogs** » Thu Sep 24, 2009 8:40 am

looks good... what would be the hardest obstical to overcome here.? I guess waterproofing which isnt even that hard... Anyway I like the strobe, someone on the boards has green and it looks pretty dope

Website · by **99BlackSandv6** » Thu Sep 24, 2009 8:49 am

I think the hardest part would just be opening the headlight.
Everything after that is just plain easy.

by **ASG14** » Thu Sep 24, 2009 8:49 am

Thats the same thing Dawgz did on his fog lights.......

by **Dawgz** » Thu Sep 24, 2009 9:27 am

ASG14 wrote:Thats the same thing Dawgz did on his fog lights.......

I think you are the only person who has seen it in person from the board....haha

by **ASG14** » Thu Sep 24, 2009 9:38 am

^ Looks better then in the pics too.

by **Ruski** » Thu Sep 24, 2009 10:23 am

looks good, but as stated dawgz has that in his fogs and that looks clean as well

by **kenny6683** » Thu Sep 24, 2009 11:12 am

i ordered these from Ebay about a year ago

http://cgi.ebay.com/2-24-LED-Strip-Car- ... 286.c0.m14

but havent put them into my headlights because i've been planning to get new ones.

These LED are super bright...you cannot stare at them long before you start seeing white dots everywhere
They're waterproof and flexible
everyones using them to do this type of mod, but those headlights seem to have single LED's inserted into housing. The LEDs i have are 12Volt as well so you just connect them to the corner lights and you're done...super easy mod

by **Ruski** » Thu Sep 24, 2009 11:39 am

those lights dont look like they have strips, the leds are spread apart and looking at the other lights they did it would be hard to use a strip

by **Ilovemylara** » Thu Sep 24, 2009 11:41 am

It would be really easy to make, Im thinking about doing it to my gen1.5 housings.

by **Projex0** » Thu Sep 24, 2009 1:17 pm

99BlackSandv6 wrote:I think the hardest part would just be opening the headlight.
Everything after that is just plain easy.

opening a headlight is actually very easy, apply heat and pull apart basically.

Website · by **99BlackSandv6** » Thu Sep 24, 2009 1:48 pm

^^^Yeah, I agree that it is easy to take the light apart, I did it with my car a while ago. I was trying to say that all of the stuff you would need to do to make these would be very easy.

LED headlight housings for Gen 1

LED headlight housings for Gen 1

Who is online