Well My gauges arrived this afternoon, and I wanted to share the awesome results. Sorry i didnt take too many pics of the install just a few, so if your looking for a DIY guide, go to this link:
http://www.cardomain.com/ride/748373/6 It only took about 2 hours and was very easy, the hardest part was figuring out where to mount the inverter and the switch/dimmer bracket.
While installing, I found it was best to "hold" the needle out of the way, so I just used my precision screwdriver lol
The clear plastic bezel had many scratches on it, so I used a little Plastx to buff them out...
Before:
After:
I've read somewhere that you should splice into the original gauge light power, but I didnt want the needles to go dim, so i wired it up to the fusebox. that is why the needles are dim, they are very bright when they are on though. After installing and turning the key "ON" YAY!
sorry, its night and my phone doesnt have flash
