HID Bi-xenon problem : stock fog lights do not work

[andrew_alfonso]

I recently installed the bi-xenon HID kit (for the headlamps) that shows I should connect the headlight switch on ONE side only that would activate both HID bulbs. Hi/Low function---no problem. HID kit working beautifully.

Except for one problem---my fog lights are dead. I believe since the kit uses only one side of the headlight switch (I used driver's side) the passenger side headlamp socket is empty. I tried installing the old H4 halogen bulb and voila, the fog lights work again! But I can't leave that there, if I remove it again, then my fog lights don't work. I tried making a series and run wires to the driver's side headlamp socket, and don't work.

Any suggestions to "close" the circuit? What went wrong?

[nemoxfishy]

Not quite sure what went wrong with your setup. But if you have time to spare... you might want to try the independent fogs mod? I think that might solve your problem...

[Eye8Pussies]

you can try using resistors- theoretically, that would work