Replacing Rear Cup Holders (gen1/1.5)
The pictures herein are from Gen4 camry. The same tutorial holds true for gen1 and gen1.5 solara's.
1.Tools Needed: Toyota part number 55630-AA10 (cup-holder), Philips-screw driver and a wrench and 12’ socket.
Toyota Part Number Picture:
12' Socket + Wrench
2.Open your center console and remove the carpet.
(for the sake of accessibility I did remove the top cover of the arm-rest; if you choose to remove this, there are two screws on top, this is again optional, I didn’t want to scratch or tear my leather).
3.You will see two Philips-screws that hold the cup-holder. The other two hold the entire unit to the floor. Remove all of them.
4.With a butter-knife find and locate the top tab that holds the cup-holder to the unit and from underside press up (see my hands in the picture where I’m pushing up).
Optional:
5.Since my replacement cup-holder was bluish/grey and my interior was tan, i repainted this to match my interior.
Before:
After:

1.Tools Needed: Toyota part number 55630-AA10 (cup-holder), Philips-screw driver and a wrench and 12’ socket.
Toyota Part Number Picture:

12' Socket + Wrench

2.Open your center console and remove the carpet.
(for the sake of accessibility I did remove the top cover of the arm-rest; if you choose to remove this, there are two screws on top, this is again optional, I didn’t want to scratch or tear my leather).
3.You will see two Philips-screws that hold the cup-holder. The other two hold the entire unit to the floor. Remove all of them.

4.With a butter-knife find and locate the top tab that holds the cup-holder to the unit and from underside press up (see my hands in the picture where I’m pushing up).

Optional:
5.Since my replacement cup-holder was bluish/grey and my interior was tan, i repainted this to match my interior.
Before:


After:


-
Jai_Jai_Binks - Desi SolaraGuy
- Posts: 5751
- Joined: Fri Jul 12, 2002 11:59 am
- Location: Friendswood, TX