by SC V6 » Thu May 22, 2003 3:01 pm
what i was saying was... there are 2 wiring harnesses for the S-afc.. one has the ends exposed, and the other is what plugs into the other harness which goes to the acutal controller.. I wanted to just hook the wires in, and not connect the plug to the S-afc... I thought maybe it wouldn't turn it on, so the engine would run as it would if it were stock, until I plugged the second harness in (for the controller) and would have it dynoed.. all I wanted to do was hook it up, so the t-taps were there, but not have it run till I wanted it to.. is this possible, can I hook the wires up, and just not plug the controller in? not plug the the afc into the ecu
on that diagram it has differnt names for the wires, than the other diagram has... the diagram that isn't shown wants, a yellow and white for air flow/pressure signal in/out, black and brown wire for ground, gray for throttle, green wire for RPM signal, red wire for power, and purple for the knock sensor... the throttle signal and air flow pressure signal out/in arn't labled in the diagram above... thats what I was wondering also...