by Jackass-Jeff » Thu Apr 07, 2005 8:04 pm
1998 CAMRY XLE... word per word from the Toyota Repair Manual... sounds confusing lol
1. The wireless door lock ECU and remote control mirror switch are connect to eachother via a PRG terminal, and the GND terminal of the remote control mirror switch connector is grounded to the body. Remove the connector from the remote control mirror switch, which is attached under the wireless door lock ECU, and use a test lead to short the PRG and GND connector together. As a result, the PRG terminal of the wireless door lock ECU will be grounded to body and will cause all transmitter recognition codes previously regustered in the EEPROM to be erased. At the same time, the ECU will respond by operating once the lock and unlock functions of all the doors and the open function again.
2. A transmitter recognition code is registered by pressing any single button of the trasmitter to be registered. Once the code is registered, the ECU responds again by operating once the lock and unlock function of all the doors.
3. To register the recognition code of an additional transmitter, follow the procedure shown in (2).
4. After completing the registration of the codes, remove the test lead from the remote control mirror switch connector terminals to allow the system to revert to the normal operation.
5. Using the registered transmitter, verify that the system operates properly.
---------
New cars are so much easier to program... lol
1GR-FE ftw!