[phpBB Debug] PHP Notice: in file /viewtopic.php on line 988: date(): It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'Europe/Moscow' for 'MSD/4.0/DST' instead
[phpBB Debug] PHP Notice: in file /viewtopic.php on line 988: getdate(): It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'Europe/Moscow' for 'MSD/4.0/DST' instead
SolaraGuy.com • View topic - trouble trouble

SolaraGuy.com

Drive faster, live longer.
http://www.solaraguy.com/

trouble trouble

http://www.solaraguy.com/viewtopic.php?f=23&t=47992

Page 1 of 1

trouble trouble

PostPosted: Fri Jan 15, 2010 6:25 pm
by Driver2g
Need some help guys. Recently did a turbo install, and I keep getting a CEL P1346. Ive done some research and found that it refers to a cam/vvti sensor. I am running 6psi and using a AEM FIC. Any ideas of what could be causing this? If it is a sensor where is it located.

PostPosted: Fri Jan 15, 2010 9:02 pm
by 1gSE
Did you intercept the cam sensor or tap it? I'm not sure about the 2AZ, but when I intercepted the cam sensor wire with my FIC, the ecu didn't like it at all. Double check the wiring. Plug the bypass harness in an see if you still get it.....but stay out of the go pedal

PostPosted: Sat Jan 16, 2010 8:33 am
by sahuddleston
never had this issue when i boosted my 2az. i had a CEL but i ended up removing the bulb as it was just my 02 sensor being removed. good luck finding it.
All times are UTC - 8 hours [ DST ]
Page 1 of 1
Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group
http://www.phpbb.com/