[phpBB Debug] PHP Notice: in file /viewtopic.php on line 988: date(): It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'Europe/Moscow' for 'MSK/3.0/no DST' instead
[phpBB Debug] PHP Notice: in file /viewtopic.php on line 988: getdate(): It is not safe to rely on the system's timezone settings. You are *required* to use the date.timezone setting or the date_default_timezone_set() function. In case you used any of those methods and you are still getting this warning, you most likely misspelled the timezone identifier. We selected 'Europe/Moscow' for 'MSK/3.0/no DST' instead
SolaraGuy.com • View topic - How to adjust the aim of the headlight?
Page 1 of 1

How to adjust the aim of the headlight?

PostPosted: Sat Sep 10, 2005 9:35 am
by stockae92
How to adjust the aim of the headlight?

anybody tried to adjust the aim of the headlight before?

thanks

PostPosted: Sat Sep 10, 2005 11:11 am
by Lone Solara
On the top of the headlight housing there is an adjusting screw right between the high beam and low beam bulbs. The screw adjusts both high and low beams at the same time; it's not possible to adjust them individually.

The adjusting screw is right under the railing that runs over the housing. There is a rubber bump to protect the hood, and right next to it there's a whole in the railing. The adjusting screw is right underneath it. The adjusting screw is like a gear on one side, and on the other side it has a 10mm (I think) head. You can use a screwdriver through the hole, or a socket to adjust the beams.

PostPosted: Sat Sep 10, 2005 12:32 pm
by stockae92
cool
thanks
i will try that

PostPosted: Sun Sep 11, 2005 9:01 pm
by stockae92
the bolt is 8mm hex :)

PostPosted: Wed Nov 16, 2005 9:03 pm
by stockae92
to aim the aim higher:

face the wind shield from the front of the car, look down to the hole on the cross beam where you can see the *gears*, push it to the left to aim high

reverse to aim low

both sides are the same direction to aim high and low

:)