redgen1 wrote:a) how much does the kit cost for a v6 auto?
b) you say you need to find a hydrolic press to install the new bushing? annddd
c) can anyone please post pictures of the install if they have them?
A. It should be about $50-$60 i think.
B. You really don't need a press to install it.
C. I just have a picture of it installed.
IMO it's not really hard to install.
All you need is the wrenches to remove the dogbone bushin' mount, hammer, flat head, and a saw.
1. When you have the dogbone bushin' mount removed from the car.
2. Take the saw and saw the silver metal band in the big part of the dogbone bushin' mount, only saw alittle bit through the silver metal band, then take the flat head and place it between the silver metal bend and the black part of the bushin' mount, and hammer away around the circumference of the bushin' mount, pry the silver metal band while goin' around the circumference.
3. For the small part, just use the flat head and cut through rubber bushin'.
4. Then again do the same thing you did wit the big part of the bushin' mount. Just saw the silver metal band just enough. Then just use the technique of the pryin' and hammerin' away like i mentioned for the big bushin' part.
5. Take out your dogbone bushin' from SuperPro.
6. Lube up the bushin' and just play around wit the bushin' til the lips of it go in the hole, and then just press the bushin' in.
That's about it.
Not hard at all.