by NeFaRiOuS_SLE » Thu Feb 23, 2006 3:10 am
OK I just got TS-A6991Rs installed in my car (can't take the rattling anymore)... A few things to note, though:
1. If you have JBL, pluck the harness out of the original JBL speakers, crimp it and retrofit it to the new speakers instead of using the factory wiring harnesses (the polarity is still based on the width, but the factory wiring is slightly wider).
2. You'll have to drill 4 holes EXACTLY under the speakers; if you're off, you'll have to either drill another hole or put it in crooked, and we all know how tacky that could get (but it's barely noticable once it's in, but it's a VERY tough job just to match the slots up)
3. You'll need a torque wrench with a screwdriver bit to reach the rear speakers. because you're given less than 2 inches to tighten the 2 back screws.
4. Like Jaydee said, watch the clips; sometimes they'll get stuck on the car body and it's tough to get out without pliers.
5. REALLY tighten the seat belt bolts to the point where it is impossible to turn it under normal force for your own safety.