Removing TRD Kit

[Eye8Pussies]

A question to those who have taken off a dealership installed trd kit before- how was it installed and how did you take it off?

I didn't install the kit on my sister's solara, so I am not too sure what to do.

I'm hoping that they had just used double sided tape and that a heat gun would work.

Also, how is the rear grey piece over the exhaust installed? I'm afraid that somebody may have used epoxy at some point in time somewhere.

Thanks !

[1st Gen Sol]

Front valences are held in by a few screws on the bottom and 3m tape, if you have the gen 1.5 kit, it should also be the same.
Side skirts have 2 or 3 screws on the front and rear while the entire length of the skirts are only held on by 3m tape.
Rear valences have 2 or 3 screws and 3m tape holding it on.
Center rear valence is held on by 3m tape and 2 plastic pop-in tabs underneath the bumper, no screws.

You should be good removing the kit with a philips head/flat head screwdriver and a heat gun.

[Mr_Krispy1183]

^Actually, aside from the two pop-in tabs, there should be 2 screws on the lateral ends of the center valence (at least with the Molly Designs one)

[Eye8Pussies]

hey, thanks for the pointers guys!

When I have some time, I'm going to take a look and see if it's worth the effort to take off the car since all the money from the sale goes to my sister anyway lol

[CamryOnBronze]

Your sister told me she would hook me up with the kit...

But yeah, just use heat and take your time- should come off pretty easily!