My speaker mounts and sound deadening

[hari-bhari]

I followed the guide on diymobileaudio, and used plexiglass to seal the large hole in the middle of the door panel. then i used raamatt on both sides in several layers. speakers were mounted to 1/2" mdf rings, surrounding by non hardening molding clay. behind the speaker is a layer of egg crate foam to absorb any back waves (this makes a HUGE difference in tightening up the bass). i tried deflex pads but didnt like it, so i switched back to foam. needless to say my doors thump like a sub now. the tweets were hot glued into the tweeter grill from the back side so it holds tight. speakers are dls ms6.


Here is the whole album: http://www.facebook.com/album.php?aid=2 ... d=12801155

[gnegroni]

Looks nice! This is definitely a bookmark for me!

[hari-bhari]

haha dont bookmark this thread, bookmark this:
http://www.diymobileaudio.com/forum/showthread.php?t=27

i basically followed the instructions completely, and like i said, went with egg crate over the deflex (Wayyyy better). you would seriously not believe how much the door thumps.

[gnegroni]

Thanks once again!

[atclate]

It'd be great if I could put these stuff around the back speakers~~~
How much are those? Where did you get them from?