Prepping car back to stock for trade-in (rmm intake)
by HydroponiK » Sun Aug 01, 2010 7:53 pm
Well I have a small issue, hope someone familiar with this intake can help.
1) The screw holding the support bracket to the fuel filter snapped off while trying to unscrew due to rust. Is there anyway to get this screw out? To improvise, I just put another bolt at the end to secure, however I'm not sure how long this will last.
2) I had to replace the valve cover vent tube b/c the kit required cutting into to install the intake. My local autozone only had heater tube in the same 1/2" diameter, is this suitable for this application?
1) The screw holding the support bracket to the fuel filter snapped off while trying to unscrew due to rust. Is there anyway to get this screw out? To improvise, I just put another bolt at the end to secure, however I'm not sure how long this will last.
2) I had to replace the valve cover vent tube b/c the kit required cutting into to install the intake. My local autozone only had heater tube in the same 1/2" diameter, is this suitable for this application?
-
HydroponiK - Regular SolaraGuy Member
- Posts: 122
- Joined: Wed May 21, 2003 7:26 pm
- Location: New Jersey