phew... it was a busy day, was doing lots of stuff around my car. finally found the time to remove the kick and knee panels on driver side and removed (unplugged) the remote starter module completely.
it was Designtech AutoCommand FCCID: ELGACLITE.
I'm still looking for an immobilizer bypass module, but was unable to remove plastic panels around ignition. can someone link some instructions how to get there? do i have to remove the huge black metal plate (hold by 4 bolts)?
how do i get the somewhat round plastic panel around ignition? damn, it's not easy, lots of other stuff needs to be removed first...
EDIT:
never mind about those panels, i removed them all today and checked visually all cables running from ignition cylinder/switch. nothing out of ordinary i think.
according to this listing, my car has immobilizer, so the question is HOW it was disabled/bypassed
http://www.ibc.ca/en/Insurance_Crime/do ... OVED_E.pdf
CAMRY SOLARA 2DR (All Trim Levels/Version) 2000 to 2007
... i just cannot find it! no bypass module, wires going to harness.
it's possible though that those wires are not going where they supposed to go in stock car though....
is it possible to re-wire ignition cables in such a manner that immobilizer would be bypassed without using a bypass module?