Hand brake ?

[netherland24]

alright pull the car intoo the garage today after driving around after i replaced my rotors... and when i pulled in and parked pulled the hand brake up and had a hard pop and then car keeped moving... i pulled console off and saw that it broke off...

has anyone else had this issue????

also how hard would it be to replace the whole cable?

thanks

[Eye8Pussies]

not too hard, since if it broke the cable at the handle, that part of the cable is only about 2 feet long and goes into a splitter under the car and then the two cables to the individual rear wheels

jack the car up, take off the exhaust heat shield, and you'll see it

[netherland24]

baller thank you guess this is my next week project

[QuickSEV6]

I hope you had good luck replacing that cable.

A couple of years ago, as I was getting into my car, I was carrying a heavy toolbox. I tried to put it in the passenger seat, but as I swung it over, it clipped the release button on the parking brake lever. It snapped right off. I went to the dealer to get a replacement button, but they dont sell it like that. I have to get a whole new parking brake lever assembly. That cost me $85. Still, it was an easy replacement.