Where to buy a knock sensor?

by **Sleeper** » Fri Jun 01, 2007 9:27 am

I blew my knock sensor some time ago and I am now looking to purchase another one. Does anyone know of a place that sells knock sensors either online or in So. Cal. for a good price? Thanks. How much should they usually run for, price wise?

by **Dawgz** » Fri Jun 01, 2007 9:49 am

Sleeper wrote:I blew my knock sensor some time ago and I am now looking to purchase another one. Does anyone know of a place that sells knock sensors either online or in So. Cal. for a good price? Thanks. How much should they usually run for, price wise?

Sorry to be offtopic here but i just have a question, what psi are u boosting at and do u have Jim's Fuel mod?

by **Sleeper** » Fri Jun 01, 2007 9:53 am

im boosting 4.5 psi with a 2 3/4 high flow cat and safc. No i dont have Jims fuel mod. how come?

by **Eye8Pussies** » Fri Jun 01, 2007 10:45 am

because without the fuel mod, your front bank is running lean, leading to the knocking and the blowing of your sensor

even if you just replace it now, you'll just end up blowing another one

for you guys without a return-style fuel setup, jim's fuel mod is pretty much a must to get fuel to the front rail

as for your question, the dealership and ebay. or a junkyard if you can find an engine that hasn't been torn apart

when I checked autozone, napa, etc back in the day, they wanted more for knocksensors than even the dealer did

by **Sleeper** » Fri Jun 01, 2007 10:57 am

How do i go about getting Jim's Fuel mod?

by **---CAMRAZY---** » Fri Jun 01, 2007 11:04 am

How about relocating the knock sensor, Ben?

by **Astro** » Fri Jun 01, 2007 12:08 pm

Sleeper wrote:How do i go about getting Jim's Fuel mod?

Check out his thread. His number is listed a few replies down.

by **Sleeper** » Fri Jun 01, 2007 12:23 pm

---CAMRAZY--- wrote:How about relocating the knock sensor, Ben?

you can do that? how?

by **Sleeper** » Fri Jun 01, 2007 12:26 pm

Astro wrote:
Sleeper wrote:How do i go about getting Jim's Fuel mod?

Check out his thread. His number is listed a few replies down.

Would you have a link to his thread?

What's up with the dyno buuuuuuuuuuddy?

by **Dawgz** » Fri Jun 01, 2007 12:30 pm

Sleeper wrote:How do i go about getting Jim's Fuel mod?

http://www.solaraguy.org/viewtopic.php?t=32654

Jim @ Foreign Affairs
2315 SE 11th Avenue
Portland, Oregon 97214
503-236-2871

by **---CAMRAZY---** » Fri Jun 01, 2007 12:47 pm

http://www.toyotanation.com/forum/t157503.html

or

Eye8Pussies wrote:otherwise, you could also just rewire your single signal from one knocksensor into two and trick the ecu that way. you can either rewire it at the knocksensor side (be careful not to ground it improperly) or on the ecu side

2 people you can hit up, one is gLok over on TN, he is here also, but doesn't frequent as much..
http://www.toyotanation.com/forum/member.php?u=42

Or ask Eye8pussies over on TN, samething, he is here also, but not as much.
http://www.toyotanation.com/forum/member.php?u=1965

JoeB had done the GM sensors.
http://www.toyotanation.com/forum/t74791.html

by **Sleeper** » Fri Jun 01, 2007 12:49 pm

Thanks Milt. I guess knock sensors are more of a b!tch than i thought

by **Astro** » Fri Jun 01, 2007 5:07 pm

Sleeper wrote:
Astro wrote:
Sleeper wrote:How do i go about getting Jim's Fuel mod?

Check out his thread. His number is listed a few replies down.

Would you have a link to his thread?

What's up with the dyno buuuuuuuuuuddy?

Oops, I forgot to post the thread :roll:

Thanks, Dawgz!

Ben, I ordered the bored TB, so I'm going to wait for that which I hope will be soon because I really want to get on the dyno!!!

Where to buy a knock sensor?

Where to buy a knock sensor?

Re: Where to buy a knock sensor?

Who is online